17 Years Factory Automatic Transfer Switching Equipment-FTQ5 for Singapore Importers

Overview:



Technical data

Product illustration

Tripping characteristic

Exterior and dimensions

Related video

We always think and practice corresponding to the change of circumstance, and grow up. We aim at the achievement of a richer mind and body and the living for 17 Years Factory Automatic Transfer Switching Equipment-FTQ5 for Singapore Importers, We also ensure that your selection will be crafted with the highest quality and reliability. Please feel free to contact us for further information.


Model: FTQ5-125 FTQ5-250 FTQ5-630
Rated current (A): 16,20,25,32,40,50,63,80,100,125 140,160,180,200,250 315,350,400,500,630
Pole: 3,4
Rated operational voltage: AC400V/50Hz
Rated insulation voltage: 800
Rated impulse withstand voltage Uimp(KV): 8
Connecting and breaking capacity: 10Ie
Rated short-time withstand current: 10KA/200ms 10KA/200ms 25KA/200ms
Operating position: Normal power on,backup on,Normal and backup off
Operating transfer time: ≤1.5
Electric class: PC
usage category: AC-33B




This video describes, in detail, how to construct a Current Limiting Device to protect you, your test equipment, and any electronic gear that you are testing or repairing. When used properly, it prevents short circuits from causing additional damage, particularly to expensive power transformers in amplifiers. It is also quite useful when first powering up previously untested and vintage equipment. It is not suitable for use with medium to large electric motors.

The bulb functions as a high-wattage resistor in which the resistance increases with the increasing heat of the filament. A “cold” bulb may offer only 2 or 3 ohms of resistance (the higher the wattage, the lower the resistance), but this will rapidly rise as the filament heats, particularly in the case of a short circuit…..protecting the circuit and dissipating the resulting filament heat in the form of light (warning you of the existence of the short).

IMPORTANT NOTE: The wattage of the bulb must be tailored to the current draw of the device being protected. The high-wattage bulbs (200W+) recommended in the video are primarily for Tube Amplifiers, which operate at relatively high current levels. With lower-current devices, such as Solid State amps, a lower wattage-higher resistance bulb (even as low as 40W) may be required for circuit protection.

For viewers in areas with 220-240VAC power: Although your voltage is double (220VAC vs 110VAC), your current flow is about half. Since the Current Limiter (CL) depends on current to rapidly heat the filament and increase its resistance, you need a bulb with higher filament resistance. Since the filament resistance of the bulb decreases with higher wattage, you should try a lower wattage, higher resistance bulb…..i.e. a 100W……initially, and then fine tune the wattage depending upon the power demands of the amplifier being protected.

The Photoflood Bulb used in this video is available on Amazon. Here is a link: http://www.amazon.com/Eiko-Supreme-Photoflood-Light-Bulb/dp/B000TZQUF0

If you enjoy seeing videos featuring classic vintage jukeboxes and guitar amplifiers, please consider subscribing to my channel, to gain easy access to over 100 related videos and to be notified when new videos are posted. Thanks for watching !!!



创业狗到底有多艰难?清华本科,MIT博士,理工科高材生,在波士顿这个创业大本营里,做着火热的人工智能项目,一年半过去了竟然还要靠父母养活?都说美国更会创新,其实中国更适合创业?听听这些创业大神的看法!

Related Products

WhatsApp Online Chat !