Best Price for Automatic transfer switching equipment-FTQ3 Wholesale to Oman

With reliable quality process, good reputation and perfect customer service, the series of products produced by our company are exported to many countries and regions for Best Price for Automatic transfer switching equipment-FTQ3 Wholesale to Oman, With the aim of "compete with good quality and develop with creativity" and the service principle of "take customers' demand as orientation", we will earnestly provide qualified products and good service for domestic and international customers.

Product illustration:

Product Features
The automatic transfer switch ensures the switching and isolation between the primary power supply and the standby power supply.Fully automatic operation ensures that loads are transferred automatically to the secondary source in case of mains failure.

Scope of use

-FTQ3 automatic transfer switch is suitable for the dual power supply system of AC50Hz, rated operational voltage 400V,rated operational current up to 250A.

-It is used for emergency power supply system to switch between two power supply, in order to ensure continuous and reliable electrical power to critical loads.

-It is primarily used in critical installations, for instance, fire protection system, telecommunication, coal mine and shipping,

-Industrial plants,residential buildings,emergency lighting,medical and health care, bank and securities exchange,airport, underground express way,

-Military establishment and similar loads that requires non-interrupted and reliable power supply.

Exterior and dimensions

▲ Plug in type overall and mounting dimensions(63-250A)

▲ Integrated type overall and mounting dimensions(63-250A)

▲ Seperated type overall and mounting dimensions(63-250A)

Controller

The silver removed from contactor’s and circuit breakers with just a map gas torch.. A oops delete of the finger.. Also a note: These pieces of silver are undergoing refining.. I’ve sent them off to Prospector’s Gold and Gem In Co.. Just waiting on the return….
Another note: This is my first silver stack just to let you know.
How to remove the silver video is here..

I recently did some research to find the best replacement trolling motor battery for myself.

When getting a battery for your boat its good to take the following into consideration:
1.Must get a deep cycle marine battery (as opposed to starting battery or car battery for trolling motor).

2. R.C. minutes stands for reserve capacity minutes which is the time it takes to fully discharge a battery with a 25 amp draw. R.C. minutes can help you predict how long you can run a trolling motor off the battery. A good standard is a 40lb thrust trolling motor on full speed draws about 42 amps continuously.

3.Cranking Amps is the amps the battery can give out in a 30 second burst. Useful if using battery to start a gas powered motor.
Marine cranking amps and cold cranking amps measure the same thing (amps the battery can give out in a 30 second burst) just at different temperatures. Marine cranking amps is always about 1/3 higher than cold cranking as marine cranking amps are measured at 32 F while cold cranking amps are measured at 0 degrees F.

4. Determine how dependent you are on you battery if you should get a cheaper battery or more reliable and more expensive battery. Personally, since my gas motor pull start I found the cheaper deep cycle battery (got one at Sam’s Club for $85) was most economical.