China wholesale FTXL Power Distribution Box to Ghana Importers

Overview:



Technical data

Product illustration

Tripping characteristic

Exterior and dimensions

Related video

To constantly improve the management system by virtue of the rule of "sincerely, good faith and quality are the base of enterprise development", we widely absorb the essence of related products internationally, and constantly develop new products to meet the demands of customers for China wholesale FTXL Power Distribution Box to Ghana Importers, We are confident to make great achievements in the future. We are looking forward to becoming one of your most reliable suppliers.


USE:

FTXL power distribution box is suitable for all types of wet and dust places and it is applicable to low-voltage distribution system of the textile, metallurgy, chemical industry, mining, machinery, with three-phase three-pole of rated current less than 630A, four-pole or five-pole, for power supply and lighting distribution with features of flexible, mobile, reliable, safe . The incoming line assemble QSA switch, partition door operated which could reduce the arc damage to the operator. Shunt switch can be flexibly configured and it is feasible to add control equipment, such as time relay, AC contactors, etc according to user requirements.

3C certificate:

hbksfsgk-1





Blue Sea Systems 100A and 150A Common Busbars are high quality marine specific busbars for consolidating positive or negative wires. For more info and other Blue Sea Systems products visit http://www.westmarine.com



Watch more Home Repair & DIY videos: http://www.howcast.com/videos/155395-How-to-Replace-an-Electrical-Outlet

If your old outlet has become so loose that a cord barely stays in place, it’s time to change it. It’s not just an annoyance—it’s a hazard.

Warning
Working with electricity is very dangerous — be extremely careful and, if you have any doubts, contact a professional.

Step 1: Cut the power
Cut the power to the outlet by flipping the circuit breaker or removing the fuse at the main panel.

Tip
If you have a voltage detector, test that the power is off by inserting the tip of it into the outlet’s smaller slot. Or just plug in an electrical fixture that you know is in working condition and test it.

Step 2: Remove outlet cover
When you’re certain the power is off, unscrew and remove the outlet cover.

Step 3: Remove the outlet
Unscrew and remove the outlet itself from the electrical box. Notice how the wires are connected to it, either by two screws on the sides of the outlet, or fastened to the back.

Tip
Take a digital picture of the back of the outlet so you’ll have a reference of what wire attaches where.

Step 4: Detach wires
Detach the wires. If they are attached on the side by screws, loosen the screws with the screwdriver. If they’re inserted in holes in the back, place the screwdriver in the slot located next to each hole to release the wire.

Step 5: Get a new outlet
Take your old outlet to the hardware store and purchase a new one just like the old one.

Step 6: Reconnect wires
Install the new outlet by connecting the green or bare copper ground wire first. Bend the tip of the wire into a loop with the wire cutter and curl it around the screw in a clockwise direction. Use the screwdriver to tighten the screw into place.

Tip
You’ll need about half an inch of bare wire to wrap around the screw; if you don’t have enough, use the wire cutters to remove excess insulation.

Step 7: Connect wires
Connect the white wire, followed by the rest of the wires.

Step 8: Replace the outlet
Replace the outlet in the electrical box, making sure the green or bare copper grounding wire is not touching the other wires.

Step 9: Replace the cover
Replace the outlet cover.

Step 10: Restore power
Turn the power back on. You can use a voltage detector to check the outlet for power, or test it with an appliance. Congratulate yourself for a job well done.

Did You Know?
Electricity travels at the speed of light — more than 186,000 miles per second!

Related Products

WhatsApp Online Chat !