Factory provide nice price XJM7-J Measuring box (Infrastructure Energy Measurement Box) for Muscat Manufacturers

Overview:



Technical data

Product illustration

Tripping characteristic

Exterior and dimensions

Related video

We will make every effort to be outstanding and perfect, and accelerate our steps for standing in the rank of international top-grade and high-tech enterprises for Factory provide nice price XJM7-J Measuring box (Infrastructure Energy Measurement Box) for Muscat Manufacturers, As we are moving forward, we keep an eye on our ever-expanding product range and make improvement to our services.


USE:

XJM7-J metering box (infrastructure power metering box) is suitable in power supply system with AC 50HZ, rated voltage 380 / 220V , as the power measurement in construction site.

 

Meet GB7251.1-1997 and GB7251.3-1997 standards.

3C certificate:

XJM7-J Mgy Measurement Box)-2





DIY soldering station with solder pot. This unit adjust the temperature of your solder iron, keeps the iron in a safe place and save solder. Generally solder flux is acidic and damages the solder iron tips but with a pot you could save your tips and reuse solder. To coat wires you have to use a lot of solder which is expensive these days but you could reuse all the waste solder in the pot.

Be careful with this circuit.

https://www.youtube.com/channel/UCQSsDr3RYfWqK65hLIkddEw



This video describes, in detail, how to construct a Current Limiting Device to protect you, your test equipment, and any electronic gear that you are testing or repairing. When used properly, it prevents short circuits from causing additional damage, particularly to expensive power transformers in amplifiers. It is also quite useful when first powering up previously untested and vintage equipment. It is not suitable for use with medium to large electric motors.

The bulb functions as a high-wattage resistor in which the resistance increases with the increasing heat of the filament. A “cold” bulb may offer only 2 or 3 ohms of resistance (the higher the wattage, the lower the resistance), but this will rapidly rise as the filament heats, particularly in the case of a short circuit…..protecting the circuit and dissipating the resulting filament heat in the form of light (warning you of the existence of the short).

IMPORTANT NOTE: The wattage of the bulb must be tailored to the current draw of the device being protected. The high-wattage bulbs (200W+) recommended in the video are primarily for Tube Amplifiers, which operate at relatively high current levels. With lower-current devices, such as Solid State amps, a lower wattage-higher resistance bulb (even as low as 40W) may be required for circuit protection.

For viewers in areas with 220-240VAC power: Although your voltage is double (220VAC vs 110VAC), your current flow is about half. Since the Current Limiter (CL) depends on current to rapidly heat the filament and increase its resistance, you need a bulb with higher filament resistance. Since the filament resistance of the bulb decreases with higher wattage, you should try a lower wattage, higher resistance bulb…..i.e. a 100W……initially, and then fine tune the wattage depending upon the power demands of the amplifier being protected.

The Photoflood Bulb used in this video is available on Amazon. Here is a link: http://www.amazon.com/Eiko-Supreme-Photoflood-Light-Bulb/dp/B000TZQUF0

If you enjoy seeing videos featuring classic vintage jukeboxes and guitar amplifiers, please consider subscribing to my channel, to gain easy access to over 100 related videos and to be notified when new videos are posted. Thanks for watching !!!

Related Products

WhatsApp Online Chat !