Miniature Circuit Breaker-FTM9-100
Overview:
Mainly used in distribution lines of AC 50HZ, rated working voltage 230 / 400V, rated current not more than 100A. For overload & short circuit protection, also can be used for line non-frequent on-off operation and conversion. The breaking ability can reach 10kA.
| Model & Spec | FTM9-100 | |||||||
| Technical parameters | ||||||||
| Standards | GB/T10963.1/IEC60898 | |||||||
| Certifications | CCC | |||||||
| Pole number | 1P, 2P, 3P, 4P | |||||||
| Rated current(A) | 63, 80, 100 | |||||||
| Rated frequency(Hz) | 50 | |||||||
| Electrical characteristics | ||||||||
| Rated operating voltage Ue(V) | AC230 (1P) AC400 (2P, 3P, 4P) | |||||||
| Rated short-circuit breaking capacity lcn(kA) | 10 | |||||||
| Rated impulse withstand voltage Uimp(kV) | 4 | |||||||
| Dielectric voltage, power frequency, 1 min(kA) | 2 | |||||||
| Isolation function | Yes | |||||||
| Class of pollution | 2 | |||||||
| Use cat. (overvoltage category) | ll | |||||||
| Tripping type and characteristics | D-type curve (10ln~20ln) | |||||||
| Mechanical charateristics | ||||||||
| Contact status indicator | Green: open Red: close | |||||||
| Mechanical life (times) | 10000 | |||||||
| Electerical life (times) | 4000 | |||||||
| IP rate | IP40 (installed inside the distribution box) IP20 (Installed directly) | |||||||
| Mechanical shock resistance (GB/T2423.5)(m/s²) | 150, continuously 11ms half-wave | |||||||
| Anti-vibration (GB/T2423.10) | 5g-20 cycles, frequency 5…150…5Hz (load 0.8ln) | |||||||
| Anti-humid heat (GB/T2423.4)(℃/RH) | 28 cycles (with 55/95…100) | |||||||
| Reference ambient temperature (℃) | 30 | |||||||
| Operating ambient temperature (℃) | -5~+40 | |||||||
| Storage temperature (℃) | -40~+70 | |||||||
| Installation characteristics | ||||||||
| Terminal type | U-shaped terminal, tunnel type | |||||||
| Max. wiring capacity | Conductor connection 50 mm² | |||||||
| Max. ultimate torque (N.m) | 6 | |||||||
| Tool | Pozi drive (double cross) | |||||||
| Installation | Installation on standard DIN rail (35mm) | |||||||
| Inlet method | Upper or lower | |||||||
| Outline dim. (mm) (L*W*H) |
1P | 85*27*72 | ||||||
| 2P | 85*54*77 | |||||||
| 3P | 85*81*77 | |||||||
| 4P | 85*108*77 | |||||||
