Online Manufacturer for Miniature circuit breaker-FTM8 Supply to venezuela

Overview:



Technical data

Product illustration

Tripping characteristic

Exterior and dimensions

Related video

Sticking to the principle of "Super Quality, Satisfactory service" ,We are striving to be a good business partner of you for Online Manufacturer for Miniature circuit breaker-FTM8 Supply to venezuela, Let's cooperate hand in hand to jointly make a beautiful future. We sincerely welcome you to visit our company or contact us for cooperation!


aaad

Technical Data

Model
FTM8 Miniature circuit-breaker
Number of poles
IP 2P 3P 4P
Rated frequency:
AC 50/60Hz
Rated voltage (V) AC
230/400
 Rated current (A)
C
6, 10, 16, 20, 25, 32, 40, 50, 63
D
6, 10, 16, 20, 25, 32, 40, 50, 63
Rated breaking capacity(KA)
4.5(6~40A),  6(50~63A)
Mechanical & electrical life:
10,000 operations
protection rating
IP20
Installation
On DIN rail 35mm according to JB6525
Connection capacity:
Cross-section of conductors up to 25mm2
Tightening torque
2 Nm
Ambient temperature (C)
-5C ~ +40C
Altitude (m)
≤2000m
Relative air humidity
no more than 95%
pollution degree
installation condition
Used in place without obvious shock and vibration
Weight (g)
106
212
308
426

Tripping Characteristic

aad

Exterior And Dimensions

ssaa

Number of poles
b
e
1P
72
66
2P    3P     4P
75
69

Wiring

Please refer to below table for the connection of wires with a cross section area

Rated current In(A)

Nominal cross section area of copper wire(mm²)

1~6

1

10

1.5

16,20

2.5

25

4

32

6

40,50

10

63

16





A story of self discovery and Fresh Moves.



normally a switch like this comes with 3 prongs,
two for switch operation (open and close circuit),
another one is for ground (for the light on/off indication)

the prongs location might differ depends on manufacturer.
however for this rocker switch,

the 1st prong (left in this video) must be connected to power (wire from +ve battery),
2nd prong (middle) goes to your accessory,
3rd prong (right) you can ignore this if you want, as the switch is already in action if you had connected the first two, however there will be no on/off light indicator though..
if you want the indicator turned on when the switch is on (close circuit), connect the 3rd prong to ground or your -ve battery terminal. (be sure to connect the first two prongs correctly) otherwise the light will not give correct on/off indication (as shown in the video)

Related Products

WhatsApp Online Chat !